Search results

95 % original sheet metal. Not original power train ...... now a 302/c4 Ford 9 inch rear end. Buddy looking to downsize $18,000 obo

This Vessel screwdriver set from my GJSS is made very well. The bits fit tight, no play, nice grip with the handle. I wonder what the instruction say ?:dunno: (Just asking for a friend :bounce:)

Unfortunately, only the main part. :sad: STEELCRAFT Made in West Germany So made between 1973 and 1989. :dunno: Need GJs help to make this whole again !!

Please give me a reality check on buying this box. Looks like it will clean up nice. What would you pay for it ? What would you ask if trying to sell ? Thanks ! :beer:

Got an old Craftsman tool pouch today and the leather is hard/all dried up. Can anything be done to soften up the leather and make it flexible again ? Thanks:beer:

Does the handle end (left arrow) thread into the middle section like the cap (right arrow) does ? I think it's a model 30. No spring extender action. No screw in the end of the handle. No other fasteners at all so I think it has to unscrew but is just stuck. :headscrat Thanks ! :beer:

Curious about this auger bit. Looks like a normal auger bit but the tang has straight sides. Never seen one like this before. Can't find any markings, it's in pretty rough shape. Thanks:beer:

Didn't think this was antique but google says it is. From the picture on Craigslist I thought it was going to be bigger than this Then looked it up and found it's from England, 1950's, and it can lift 1000 pounds ! (Is that 1000 pounds American ?:beer::bounce:) For 10 bucks, how...

Does anything look interesting ? Looks like his prices are coming down on some stuff. Is that last plane on the right really rare ? (I haven't seen them in person.) Thanks :beer:

This tool box is in really rough shape. Does it have much (any) value left ? Thanks:beer:

Any hope of getting this bit straight ? Without a tang, it still holds well in a brace, or I use it with a drill in low gear. Hard to see in the pic, but the tip runs out over a 1/4" Aside from figuring out where and what direction the bend is, how would you suggest trying to get it...

I've been trying to find info on this brace/bit for a while. The lever at the end of the brace engages with the notch in the bit to hold it in place. Just had a break through while posting this!!! I think the markings say GLASGOW. Other marking I can't make out MA_A_ESON Thanks...

Is there anyone looking for any and all old open end wrenches. There was a half dozen or so along with this stuff on craigslist. (In a different box, not in the picture.) Stupid me, I didn't take any pics of them. :twak: They were open end on both ends, average size, very thick rounded...

What catches your eyes. Unfortunately, someone got to the block plane before me. But, I did pick up these four ($5 each). I've been looking for a saw set for ages!!! Looks like it still works perfect. Can't find any markings. The wrench movement is smooth as silk. It says "Solid...

Since it seems to have worked, I want to show everyone how I made my Millers Fall #120 hand drill usable again. The axle (?) shaft or the frame (or both) were so worn that the ring gear and pinion gear just wouldn't stay meshed. So, to remove the slop I built up material to the shaft by...