Search results

Hi, I'm modifying an old linishing machine to fit a sanding bobbin on one of the drum shafts, basically I want to extend a 5/8" diameter shaft and couple it to a 1/2" diameter shaft, in line without using gears, although that would be nice later on, which hold the sanding bobbin. I've seen...

This is an update on an earlier post so apologies for the repeat. Awaiting contact from a forum member but thought I'd try the forum again. I'm looking for assembly drawing or exploded diagram for an old B&D drill. The model is the V820 Mastercraft, 13mm chuck 400w, two speed. It may be...

I am looking for an assembly drawing or exploded diagram for an old Black and Decker Two Speed Drill. The drill was jammed so after disassembly/cleaning and new brushes I think it should be fine. Unfortunately I don't think the bearing, washers, spacers etc. are in their correct places. Does...

Hi new member to the forum so hello. Looking for some information on a Record No 3 4" vise. When the vise is closed to clamp an item and then released the jaws remain closed or jammed, to release the jaws usually requires tapping the slide or jaw. I think this may have been apart before so...