Search results

I searched but don't see any posts regarding these. Has anyone tried these cabinets?? Torn between this and the Seville ones from Sam's Club http://www.menards.com/main/more/garage-tool-storage-sale/2-door-wall-cabinet/p-1458890.htm

Hello Everyone. For those of you installing a lift like the MaxJax, has anyone had trouble pounding the anchors into their concrete? I drilled the first hole out 5/8' and then finished it with a 7/8" bit (as required but the anchor instructions) and cleaned the hole out with air but it was very...

Hello Everyone, I need some "advice". I have searched but did not find an answer to this question. I have just started prepping for epoxy and have etched my floor 2 times now with a 1:1 Muriatic Acid:Water ratio and there are spots where it is not quite the texture of 100 grit sandpaper. In...

I appologize if this has been covered elsewhere, I did a search and didn't quite find my answer. Is it possible to lay epoxy down in cold weather in an unheated garage? I am faced with coating my floor now before winter and it seems like winter is about to arrive with the low temps we have...

Help!!!! I installed one of 2 new Liftmaster 3800's and it wobbles a lot. How much movement is acceptable? It seems like it moves way too much and sometimes it sounds like it's binding. The torsion bar is only long enough to extend 1" into the unit. I tightened the collar on to 12 ft. lbs...

Has anyone used this or a similar product? http://www.homedriveway.com/images/pages/concreteproducts.htm They have it at Menards and I want to seal the edge of my single pour slab (the exposed porthon under the walls) to prevent mosture from seeping through. I plan on piling dirt up to the...

Where did you get yours? I know E-Bay has thenm for $298 shipped and I'm still waiting on a reply from nova65ss to se what he can offer but wanted to see if ayone has gotten them for less??

Hello everyone, I'm having a 15' high 28'x22' reverse gambrel roof garage built by a garage builder and they are using only five 2x6x22' to span the loft area. The salesman states I could purchase my own 2x6x22' lumber and have them install them when they build the garage. I plan on having...

I don't know if this has been covered or not, if so I appologize. Has anyone used single color chips in their epoxy floors? This would allow you to sort of use the chips as texture but not have to worry to much about the camafloge effect when you drop a nut or bolt.