Search results

hello guys I recently bought a enco 109-1005 and I do not have any owners manuals it could use a couple new drive belts does anyone have on of these that could help me to figure out where I can purchase the new belts I can not seem to find any info on this machine at all on the WEB

wondering if any one has run into this I just fired my new to me compressor and the small air line that runs to the pressure switch blew off it appears to be a push lock fitting I have not taken it apart yet is the fitting replaceable or does it need a complete new on off switch assy?

does anyone know what shade of red will match a husky air compressor best? hoping to paint my bench to match with out to many trips to the home depot

hello guys im in the final stages of finishing up my garage I noticed that where the floor and foundation meet there is a small gap and I can feel the cold air leaking thru what can I use to seal this up. I also want to paint the foundation inside the garage with some type of moister sealer...

getting ready to plumb the garage for air have a 60 gallon tank and plan to add a extra 20 gallons because I have it garage is 24x24 going to have a 24 ft run the 90 to another 24 ft run with 4 drops. I plan to do the drops in 1/2 my question is do I run 3/4 for the main feed or keep it all 1/2...

hello guys getting ready to insulate the garage its 24x24 I am planning the use R13 in the walls not sure what I need in the ceiling. its 2x6 construction on the ceiling I have a attic above the ceiling with a floor so my plan was to insulate and then sheetrock the ceiling since the attic...

got to cut out a main P trap in my house for the main sewer line and I plan on using PVC in place of the cast trap. I have a 4 inch cast main vent on the house side of the trap now my question is does the vent need to go back the plumbing is all new and updated in the house with traps on all...

need to buy 7 square D circuit breakers where are you guys buying from the big box store (lowes & HD) must think they are gold plated. any good places to buy on lines Thanks Jeff

hello guys im starting to wire my 24x24 garage going to have 2 50 amp plugs for my welder in case I need to be outside the garage to weld something up my question is how can I wire these do I need to have 2 separate circuits from the CB panel? I will only be using one plug at a time so I am...