Search results

Good afternoon, I finally bought a used challenger VLE10 lift and got it up and bolted down. My problem now is that the arms were not removed when I bought it and I installed it’s a different way then they had it set up. So now the long arms are in the front and the short arms are in the back...

Hello all, I’m starting a S-10 frame swap for my 49 Chevy which will include extending the frame in the process. I bought myself a Lincoln 140 welder to use for this project and what ever crazy Idea I decide in the process. I’m new to welding but want to go the gas route rathe than flux. I...

I know this has been discussed but I have a question about lift wiring. I’m going to run 10-2 off a 30 amp breaker across my shop to where the lift will be. It will be a little over 50 ft. I don’t want to have a bunch of extra wire due to the cost of wiring right now. Is it acceptable to use 2...

I just finished up a barn wood wall and have enough pieces left over I was thinking about building a desk. My delemia is what to use for the desk top. Any thoughts or opinions. Thanks

Ellis Acre dream shop ( AKA Badger hole) Hello all, Been lurking and asking a few questions over the last year or so. After moving around the country for a number of years, me and the wife finally decided to put down roots and purchase a small piece of land in Northern IL last fall. I have...

Good afternoon, I am getting ready to start my project in the next couple of months and will share when I get started. I am debating adding a 8x7 single sliding door on the side of my building to use without having to open the 16x13 overhead door. I am thinking this would also be a good way to...

Been lurking for a year or so and I am about ready to start my shop. My plan is to build a 40x60x12. The unfortunate thing about this project is that I am not handy enough to build the shop on my own. I spoke to one builder who was way out of my price range. I am really considering buy a kit...