Search results

Has anyone done the rubber wiper mod to their snow blower impeller? Apparently the cause of clogging and weak stream is due to the gap between the impeller blade and the housing. Im not smart enough to engineer one of these machines but I am smart enough(just barely) to know they were designed...

Ive been shopping for a used toolbox on facebook marketplace and have come up with a way to determine whether im paying too much. I started calculating the price based on cubic inches of the box and determined based on observation that a price of 6 to 8 cents is a good ballpark estimate on what...

So I have an 80 gallon Curtis horizontal tank that Im rebuilding a quincy 325 for. The inspection plate says 220 sides and 190 end caps which is way thicker than most tanks they make today. Id like to rehab it but I am concerned about the fact that there are no fittings on the bottom. Can I...

Hello all, I just picked up a 325 ROC 104 and it needs a new bushing/pin on the HP side. The bushing quincy sent me is too long. Did they send me the wrong one? Are these supposed to be exact fit from the factory or do they require a machine shop for fitting like a race engine. Thanks in advance!

So i finally got my first real air compressor. I picked up a Quincy 325 from a company that was moving and couldnt take it with them. The roc is 104 i paid 400 so i think i made out pretty well. Its an older curtis tank and a 5horse 3phase that i will be swapping out. I plan on downsizing the...

Are there guns stronger? Sure. 2131 will take off everything except a honda crankbolt and its relatively small. At least when I did this for a living. And that was before milton hi flow fittings. GREATEST GUN OF ALL TIMES.

I just bought a 30 gallon champion with a c1 pump. It has a small hole in the bottom of the crank cover. Is there supposes to be a tube attached to that. When i cover it it is noticeably quiter and thats what im looking for. Thanks