Search results

Any of you guys do any prep in a complete metal garage. Mine is going up today and I am looking to order something for floor asap. I will be using this for my own personal car workshop. I at first was leaning toward just ghostshield 8510 since its spray and use a roll out mat under lift. However...

Looking for a 2 post for my garage. Not looking to spend a fortune cause it will be personal use only so not going to be used to frequently. Heres few I looked into. Anyone got any input? -Eagle equipment there is around 1600 and couldnt find really anything good or bad about them in general...

My 18x 40 metal framed garage should be going up in next few weeks. Trying to figure out last few things. Garage is located in florida. Looking for opinions on following. Garage has roll up door on both 18' sides. 1. Adding and inlet vent and exhaust fan to help circulate and move hot air out...

I just had a 18x40 slab poured for garage yesterday. They knew I was adding a lift so they cut 1 control cut down the middle long ways and also 1 down middle short ways. They did it cause the cut would have been at 10ft and lift is going at 12ft. I am kinda wondering if I should have had them go...

Grading for my 18x40 metal tube garage is happening today. Hopefully by first of next week concrete will be poured. Have a few questions. 1. Should I have them do a power trowel finish or brush similar to a driveway? 2. Right know I am leaning toward treating with Ghostshield 8510. Not really...