Search results

Hello I recently sourced a nice Beach cabinet . I also acquired with the cabinet in jammed drawers a couple of pullers and some other bits and bobs . I have a couple I can’t identify. The second possibly a bearing puller home made ? regards terry

I have a Tecumseh 8hp on a snowblower . ( found unit ) It was backfiring out the exhaust . I redid the valves and re gapped them to 10mm . Started it and it is still firing through the exhaust . It is also pushing oil out through the valve cover gaskets . Pulled the head again and found a puddle...

I bought this Canadiania Tiller ,has a Briggs 5 hp motor with chain drive . circa mid seventies . The drive was damaged ,seals ,needle bearings and chain from sitting outside . Long story short . I disassembled without taking pictures . Does anyone know where I can find a Manuel or parts...

I acquired a 2hp lawn edger with a 2hp Briggs - 060102-0429-01 I thought the points were stuck ,no luck it seems the rod which moves the points from the crank is defective . Would anyone know the part number ? terry

In one of my wiser moments I decide to change the oil in my compressor . Unfortunately I am unable to seal the pump to hold oil from seeping from the drain plug . I have tried plumbers tape and plumber’s blue goop can’t remember the name . Is there stuff I can use that will hold the seal under...

I have dragged home a 3 hp B&S roto tiller which has been abandoned for several years . The serial and engine Id are on sticky attached to the rewind housing . It appears to have been painted over at the factory or some other fellow was there first . Regardless I tried sanding and have...

I recently purchased a vintage beach tool box . It has had a rough life ,rust and dents abound . I would like to remove the handle and the metal beach emblem . Before sanding and painting. Where would I source the rivets with the large heads

Hello I recently purchased a Vintage Snap on wrench QJMR-210A I have found conversion tables for the settings What I have not solved is band around the base in increments of 10 to 40 is this a multi indicator eg 400 with a indicator of 10 =4000 cm.kgs Any help would be appreciated Regards Terry M