Search results

I know this was posted a while ago but I talked to Brad from mr. heater service today and he said the directions are not real clear on size , but it is suppose to be 4" when venting horizontal and it can be tipped down a little for condensation to run outside. I already ran 3" so its a...

I have a big max 45k btu heater in a 625 sq foot garage. It has 3 1/2 insulation in the walls and 6 in in the ceiling. I have a ceiling fan I run all the time on medium. When I am not out there i keep my thermostat at 42 degrees. When my furnace kicks on it only runs for a minute or two than...

I have a big maxx 45k heater and i vented it out the back of my garage with 3" b vent. It faces the north so when its really windy the flames shut down inside than relight again. I am assuming the exhaust is blowing back into the unit so it is turning the flame off. If i put a 90 elbow with...

It took me only 2 hours to figure out how to post these pics of my floor :lol_hitti

I used Sherwin williams macropoxy 646 thinned down 20% for a primer, and than full strength for a intermediate coat along with some flakes. I topped it with a product from sw called Rexthane ( its a one part, moisture cure, solevent based urethane). Everything I used was solvent based so it...

I just got done putting down a coat of sherwin williams macropoxy 646 which is a two componet 85% solids solvent based epoxy with flakes on top. I was told to go over it with a epoxy clear coat which is high solids solvent based epoxy, I was told the floor and the white flakes will yellow over...

I am going to acid etch my floor, after i do my final rinse how long do i have to let the floor dry out bfore i can epoxy my floor? I will be using sherwin williams macropoxy 646 which is a two part solvent based epoxy. Its been in the 60s and 70s lately if that helps. Concrete is 7 yrs old.

Has anyone tried it? I went to sherwin williams today and the guy told me he has done 4 garages with it and had good luck. One of the guys drives a bobcat into his garage daily and no problems at all. He just stressed prep is the key thing. They sell it for about $150 a kit ( 1gallon part a...

I was looking at old post but I never saw a real answer to this. How slippery is the tile with snow on your tires or your boots? Is my car gonna be able to stop when i pull in full of snow, or am I going to be able to walk across the floor without cleates on my boots? :bounce:

I installed a heater this fall with a horizontal vent going through my sheetrock/insulation/osb board/vinyl siding. Tonight when I ran it for a little while is was 15 degrees f outside and about 40 degrees inside. I warmed it to about 50 degrees and I noticed condensation running down my...

I am running my venting horizontally on a house with vinyl siding, do you just use a thimble on the siding and than silicone around it? Or is there a better way? Pictures would hlp. thank you

I am installing a mr. heater 45000 btu natural gas unit. I have a newer house with the 2lb. gas system, do I need a gas regulator? If I do, I have my main line comming into the house, than a regulator, than a gas dryer and a water heater. Could I add my heater onto that regulator as well?