Search results
-
M
Will a second coat of polyaspartic fix these roller marks?
A company is coming by today for the 2nd and final topcoat, this morning I noticed these marks. They mixed and poured more when they ran out of polyaspartic and then back rolled at 2 different times. Can they be corrected? How ? The owner has been good to work with. Thank you! -
M
Concerned about concrete showing before polyaspartic over full chip. What should I do?
A company is going to vaccum and scrape full broadcast chips before laying down the polyaspartic top coat today. It looked great but The issue is upon inspection there are many areas where it looks like there is almost no epoxy as if too little was used there or the concrete absorbed it. Will... -
M
Garage floor system being installed today - question on topcoat please
I have an epoxy company installing a floor system today in the garage: part of it gets sun.. They are about to do a full chip broadcast and then applying 1 layer of polyaspartic top coat. In the past, I have seen garages that are quite rough due to the topcoat not being thick enough over chip, I... -
M
Should I sand and epoxy over this or topcoat to improve?
Hi all, happy Sunday. was hoping someone could help with some advice. This floor was installed a year or 2 ago extremely sloppily. The bond seems good but It shows all of the imperfections of the concrete. Concrete wasn’t grinded at all. It was 100% solid epoxy followed by single coat... -
M
Polyaspartic top coat not curing over epoxy?
so we went with a 100% solid epoxy base, chip broadcast and then 80% solid polyaspartic top coat. The top coat was rolled on thin around 12p today. It was seal Krete poly 8000 which I included the tech data link below. It’s been almost 8 hours and while it’s dry, I can still put a scratch in... -
M
100% epoxy solid clear topcoat or Polyaspartic
Good morning everyone, I am working on fixing a bad epoxy job. The installer used 100% solid epoxy and full broadcast chip, no topcoat. I called him back and he offered to put a 100% solid clear epoxy as the topcoat. Is this standard at all or recommended? Wont this yellow? He used seal krete... -
M
Botched epoxy job? Any fix?
Hi everyone. So I went with a small local company to do an epoxy floor in our garage and he didn’t do it the way he said he would. The floor was pretty rough and pitted. He acid etched then put down 100% solid epoxy that he mixed and then full broadcast. The issue is (included in pictures - 1...