Search results

My Modine Hotdawg exhaust blower is slow to start when it's cold in the shop. It may take a few resets to get it moving and then it runs fine. Is there anything I can do to help that fan motor get moving better? I don't heat the shop regularly. The heater is the 75,000 btu version. Thanks Phil

I currently have a Snap-On tools box with a bottom and top box and it is getting too full. I am considering buying a HF 56" toolbox as a second box. I plan to keep my existing box and move into the bigger box and use the existing box as extra space. Here is what I am looking for: 1. Have any...

I want to purchase some swivel impact deep sockets. I have shallow swivel impact Snap-On sockets. I am considering purchasing some other brands that are cheaper. Does anybody have any experience with sunnex or other brands. I don't see the sockets getting a ton of use but cheap tools can...

I have a craftsman drill press floor model and the bottom is not flat or the floor is not flat. I don't want to permanenly mount it to the floor. I am looking for good way to get it to quit walking around. I have tried shims but the drillpress is too easy to rock it around and the shim gets...

Saw these at the hardware store yesterday. What do they do better than something else?

My bluepoint flashlight is about to die and so I need a new flashlight for the shop. I want to get a LED light. So whats new in the tool world for flashlights. I don't want any junk. Thanks Phil

I want to make a roof for my UTV. What aluminum do I want so that I can bend it to make a rain gutter on the front and sloped edges. My idea is to get .10 aluminum diamond plate make a carboard template and bend and weld the sheeting to make a roof. By the way I don't have a break is there...

wanted inch-lb torque wrench. Let me know what you have to sell.

Looking for silver solder info. I want to replace a couple of broken sections of carbide on the skegs for my snowmobile. I have been told the carbide is silver soldered to the host bar. Are there different types of solder and what flux do I use. Will it matter that I could be useing a...

I have a Chinese 8" bench grinder and want to replace it with something with some power. I have read lots of reviews on different grinders Craftsman, Dewalt and Ryobi and all seam to have issues. What do guys that have bought grinder recently suggest. I would like to keep this under $200. Thanks

I am looking to buy some push pin tools. Honda uses a lot of these to hold the plastic parts on there cars. What have you bought and do they work well?

Wanted 3/8" drive metric swivel impact sockets looking for set in standard depth. What do you have for sale?

I am looking to buy some extra metric imact sockets larger than 19mm. What are the most common used metric sizes above 19mm? I will need to buy individual sockets so I don't want to buy sizes that don't get much or any use. I don't think I will need any over 35mm or 36mm or do I ? Thanks

I poured a 22x24 slab in fron of my car garage and the concrete is spalling. I have an idea of buying a floor grinder and grinding the surface off. The grinding would get rid of the spalling and atleast make it look all the same. I have seen 5" floor grinders in the threads for epoxy prep and...

I want to put in air line piping for my garage and I am looking at using Pex tubing. I was at Menards yesterday and 3/4" pex is rated at 160psi. I want to know if this is safe. I would use copper but 3/4" copper is in the mid $20's a stick and 100' roll of pex is $40.00. Thanks.