Search results

After three years of use I have had some issues. Lots of yellow tire marks from a 6000 lbs tractor. But I did not put a clear coat on ,went with 3 coats of gray instead. Have had some deep scratches from stones stuck to the bottom of a pallet of firewood, dropping metal pieces on the floor. I...

Finally decided to go with the Legacy Industrial Nohr -S mainly for the ease of use, because I would mainly be by myself. The saw cuts where filled with sand and then the gel crack filler. The floor was ground with a HD diamabrush unit done with water to keep the dust down. Then the floor was...

I installed my wood boiler in the detached garage heating it with the boiler residual heat, stack pipe, and copper pipes exposed. and some radiant floor heat. So far working very well, with some bugs still need working out.

I have a portion of my ceiling to insulate, below my attic area. The space of the bottom cord of the truss is 5 1/2", I could use fiberglass insulation R-21, or 3 layers of Dow blue board R-27. The ceiling will be finished in metal so I'am worried I might have water vapor that can't migrate up...

wiring my garage now and planning on two liftmaster 3800 openers, I wanted a unclutterd ceiling so would like to have one light operate off both openers. I contacted liftmaster their optional light needs a receptacle and would come on by radio signal from opener but both cannot operate one light...

planning on T8's 48" bulbs, ideas on placement would be Great. Thinking on down the center between the bays and on either side of each bay, and some in the shop area. Cieling height is 10' and 10' up to 14' at the peak of the truss. I can't do anything with drawings so here are some pictures...

New garage has 10' ceilings with scissor truss giving me 3/12 pitch at ceiling 13' 6" at peek. Garage doors are orderd and comming in soon tracks are to fit the 3/12 pitch. Now looking at my current garage has 10' ceiling with standard door tracks which hang 19" from ceiling, should I have...

ready to start framing with no set plans shy of entry door placement. Question is planning on putting three windows in, one on each gable end and one in front of garage size would be 48" wide 36" tall vinyl sliders. How far off the floor and is that a good size ??. I have a Thread started under...

The garage build site was was started in november 2010 with one big problem, a large boulder on the mound which needed to be removed where the garage is to go. Here are some pictures.

I will be pouring a monolithic slab in about a week looking for recomendations on saw cutting slab. size is 30 x 40 right side of garage will be poured flat left side between two overheads have a slight pitch to 40" trench drain. I don't know if this layout is best?