Search results

Senco (new) Staple Gun Woes, issue fixed Hello to all, I just purchased a Senco SL150MG, a basic 18 Gauge 1/4" air stapler. The tool will not drive a single staple. I am at a total loss and hope someone has some suggestions. I have the tool hooked up to a Porter Cable air compressor which I...

Good day to all, I am putting up a picket fence, a lightweight garden fence, wife says no screws, no nail heads! At a former residence, I tore down an existing picket fence that had the pickets attached with staples, amazingly it was rock solid and the pickets were surprisingly very difficult...

Best way to cut PT 4 X 4 fence post w/circular saw (Update Issues) Hello guys, I am putting up a privacy fence in the backyard and getting ready to cut about 40 pressure treated 4 x 4 (3.5 actual). I am using a circular saw, put in a new blade already. They are in concrete already and I am...

Craftsman Shop Vac blowing dust from motor (update fixed) Hello to all; I have a Craftsman wet/dry vac that is about 20 years old. It has always worked well and still has great suction. It recently started blowing dust from the ports around the motor head, this only happens for a few seconds...

I have seen all the threads were everyone speaks so highly of the FEIT LED Costco lights, I am not sold. I have been burned before on MFG quality with outside motion lighting until I found RAB. Has anyone seen/used the RAB PORTO, seems interesting. I rarely post on this board but would welcome...

I have a Genie Pro 1024 belt drive garage door opener. The logic board failed and I changed it myself and it works great BUT I damaged the rail or tension pulley during the repair. This is the pulley the drive belt goes around located opposite of the control unit. The pulley is plastic and...