Search results

Check to see what insulation is used in the 2 different doors. What are they doing to the door to get the extra R-6? When i installed mine the guy installing said there are 2 kinds of insulation in these kinds of door (I forget what the 2 were). He said the higher R value door is better when...

Just had a system installed. My number was 65. No sump. 4" PVC in two locations. Will be testing next week to see what the new # is.

This may not be enough water but what about the pumps in waterfalls or fountains that you use in landscaping?

I bought a product called Quips from Insulation solutions. If you call they will send you out a sample. I attached the pex to wire mesh. They worked really well.

Not sure where you are located but i found 25 psi EPS for under slab. It was $27 a sheet. You might find the 150 or 15 psi stuff hard to work on. I will break/crack easier. If you try and search on here there are people that used insulated doors that were defects/ blems.

My parents just bought a refurbished heat siphon heat pump for a 24' round above ground pool. Pool was 61 on Monday and 84 yesterday. only ran it during the day. Seem to be doing well. Not sure what it will cost to run though. Other neighbors pool with no solar cover on and no heat is still in...

Nice! You planning your layout for the future outdoor furnace or will you just redo if needed when you install the outdoor furnace? Is that just duct tape you used to tape the insulation together?

Thanks again. Very helpful and good info. I was concerned the PEX wouldn't stay in the Hydrofoam. You have any pictures or point me in a direction of pictures of the box you made? I understand what you are describing but would still be nice to see.

Thanks for the additional info. My guess is the staples he is talking about are the ones meant for wood and people are using the wrong staples. It sounds like you have used the Hydrofoam before. I am curious as to what is so hard about it? The video does make it look very easy.

Thanks for your input. The guy pouring the floor said he has done many floors with pex stapled and the staples always come out (he didn't specify the kind of staples that were used). He said to use wire mesh and tie pex to it. $1300 ish foam and mesh. $1600 ish hydrofoam.

Has anyone used the "Hydrofoam" made by Nudura or any products like it made for radiant heat? Thoughts Has anyone used Pert instead of Pex for radiant heat? Thoughts?

Thanks for the info.

Very nice. I would like to ask a couple of questions. Don't take it as a put down or that anything is wrong. I am just trying to learn. 1. It doesn't appear very deep but did anyone say anything about not back filling until you had weight on the block walls? 2. It appears that your seal plate is...

Thanks for the added info!

I called the Lowes # twice. They had no explanation. Just that they had a lot of calls about it. I told them I would not be shopping there until they had gift cards at Giant Eagle again or could explain why. I left my name and #. I heard over the weekend that Giant Eagle gets the cards to sell...

Anyone get gift cards from Giant Eagle for Lowes to get the fuel perks and notice that Giant Eagle doesn't carry Lowe's Gift cards anymore? Not happy about this...

Maybe a dumb question but if rebar just holds together concrete if there are cracks and you are putting control joints in, couldn't you run rebar just in the area of the control joints only? Maybe like 3' pieces perpendicular and then tie them together parallel to the control joints?