Search results

Depending on your jurisdiction: 1. Connect rain-tight 3/4 EMT connector. 2. Thread into 3/4" rigid coupler (threaded coupler) 3. Thread a 3/4 metallic strain relief into the coupler. The only caveat is that you can only get 1 conductor per pipe.

It's fused, and allows for an easy transition back to 50 amp if required.

Could have just used a conversion plug as well...

If LED's are used for lighting, some of the accept wide DC input voltage. You may be able to have a fully 48 Volt system. Same goes for the coil on the contactor.

The air chamber needs to be sealed. I've used female pipe threaded cleanouts for this purpose. My setup is in a 4' deep sump, and goes from the check valve to the bottom of the lid (approx. 24")

It's probably a point to tie in a wireless remote or other such accessory. Can you provide a manual or model info to verify?

I've had these for 10+ years with no issue. https://www.newegg.ca/tripp-lite-tlp76msg-7-outlets-nema-5-15r/p/N82E16882750082

Your from Ontario- the easiest to get ahold of here are the 30* paper strip nails.

Holy moly! Another North Bay member! If you need assistance with the install, I'm in the area!

Thanks for the reply's all, I mentioned "Blue Skin type product" due to it being a similar Canadian brand. I've searched for pre-fabbed stucco/ cement covered foam panels with no success. I currently have plans to install Delta wrap (plastic dimpled foundation waterproofing/ water shedding) to...

Hello all, I've recently waterproofed the foundation on my home with a blue skin type product and it states that it needs to be covered and protected from sunlight within 90 days. Does anybody have a good method ov covering it up that also looks visually appealing? Id have at most 24" exposed...

The red conductor passes a 9v signal when in alarm state a would be inherently protected by the Limited output of its source. if you look in the specification sheets for your smoke detector it will have a maximum output rating, somewhere around a quarter amp if that. I can't speak to the NEC...

Could you put a regular female cord end on and then use a small tried tap to get 3 out if it?https://i.ebayimg.com/images/g/sCoAAOSweW5Vd4AM

What kind of loads are you expecting on your second floor? I see you used the ICF system for the floor, was it easy to erect? The garage I'm planning to build is a single car, maybe 14 x 28 or close to, depending on what the town will allow. I was hoping to have a "basement" with floor to...

Agree completely on the engineer. I have a One ton truck and don't want it in the "basement". Like I said, just attempting a material take off to assist in budget generation.

What size beams on what centers? I have no intention of winging this, just curious what sort of budget I'm looking at.

Anyone done a 2 story garage with drive in access to the 2nd floor? I'm curious what slab thickness and construction techniques were used. Any direction would be appreciated (I've tried the search function but can't find the right terms to narrow results)

As others have said, increasing speed isn't a good idea as that directly affects frequency. Try a 40uF cap to boost voltage as the one that you replaced may have been undersized to begin with. As long as you test voltage before you plug something in you can't damage anything.

Like others have said, pilot through and hole saw. For trimming the outside, try these, they make quick work of the job and look good. http://www.royalbuildingproducts.com/siding/products/mounts/

Any way to stub it out right beside the down spout? That way it could be hidden and drain onto the same ground diverted at the bottom. Small length of heat trace in 1" pvc drain if it's going to be run outside for any considerable length.