Search results

I was looking at the same 2 lifts and ended up with the Bendpak because of the minimum lift pad height listed was about an inch lower on it.

I used tongue and groove cedar for the ceiling and one wall below a staircase. I stained it with clear deck stain and it looks really good.

Tie a rope to the ramps and put the other end of the rope under your back tires, it doesn't take much to stop them from sliding, I used about 3/16 diameter rope.

CDI makes a quality torque wrench, I'm pretty sure they make them for Snap-On, I have one of each and they are identical and the CDI cost less than half of the Snap-On. They also come with a calibration sheet.

I'll get a picture tonight when I get home from work.

I installed my XPR-10A with the power unit on the left side like this one, I had to add a couple small clamps to hold the cable closer to the column because when the lift got near the top of the travel the carriage would contact the cables and stop the safety latches from engaging.

The reverse switch is on the fan behind a cover on the back of the motor.

I have 2 of these in a 36x48x14 and they move plenty of air. I mounted them in the peak with 4' downrods.

I just went through this yesterday, you can see where the tabs are welded looking on the outside of the carriage, my arm fit through the opening on top and I was able to just drop the cable into place.

Chapin 97700 12-volt EZ Tow Dripless Sprayer, 25-Gallon This is the one I just got, it works great so far.