Search results

Testing how to post inline pictures from photos stored on the Garage Journal site. Looks like it is working as expected.

I have used the BendTech sheetmetal module. This was prior to Fusion 360 implementing its sheetmetal capability. I suspect now I would turn to Fusion 360 before I would use BendTech if I needed another sheetmetal part. My first significant sheetmetal part was the fabrication of modified...

Re: PHOTOBUCKET is holding some member's photos as hostage. what are the best options Cool, my name is now in red. Thank you for raising my awareness.

slodat, cool. Glad to hear it. I was thinking it would be more. I installed a fan in my cabinet (I'm converting my Jet drill press to VFD). I have a two horsepower motor as well. And my drill press would not run for long periods of time like a motor in a paint booth. Sounds like I may not have...

slodat, how do you plan to deal with the heat build up in the cabinet from the VFD? Britt

I am able to get Flickr to work on my laptop but not my iPad. I'll need to sort that out.

Scaled to 480 x 640

I was able to get it to work but I need to scale the picture first. Need to put at end. A lot of extra typing when Photobucket would do it for you. I need to figure out how to scale images on my iPad...

65acode, thank you for the nice words. No, I do not have a build thread but I need to start one. If I do, unfortunately, I'll be starting in the middle of the project and then working both directions - forward as a I complete new tasks; and backward to show what I've already done. You may just...

Re: Attention GJers-Check your Photobucket accounts I read about the change in Photobucket's terms of use on another forum. I checked my Photobucket account and the pictures I have linked to on this site and everything appears to be intact. I've been paying Photobucket an annual fee to avoid...

When I plumbed the air lines in my shop I installed Sharpe regulators at all my outlets. I've become very frustrated with them lately as they don't seem to hold the set pressure very well. I end up with pressure creep sometimes as high as the pressure in the tank. This is fine for air tools in...

I've been working on the exhaust system for my 1967 Ford Mustang Fastback build. I'm running a Ford Coyote 5.0 L engine with Doug's Headers so there is not much "off the shelf" stuff I can use. I'be been working on my back and at times I wish I had three or even four hands. Started at the...

That is very cool.

I always wanted to see the bottom of one of these. Not sure that tipping it over in the aisle while in flight was a good way to do so though. :eyecrazy: Britt

Very nice. I like it. Britt

Thank you for the replies and feedback. I have the software on my computer but have not tried to use it. From the YouTube tutorial I watched the libraries are massive and not organized. I know the switch manufacturer and model number so I hope I can find it in the library. I'm going to give it a...

Has anyone used Autodesk Eagle software? It is very similar to Autodesk Fusion 360 except it is specialized for printed circuit boards. I'm thinking of developing a simple printed circuit board to mount a 16 position rotary switch for a VFD project I'm working on to convert my Jet drill press. I...

Looking at my original post it only took me eight months to get this done. Procrastination and the need to develop some solutions held me up. Following the link to jalopyjournal.com posted by K13 I made the necessary tooling to set the precise angle necessary - 57 degrees. Using a cam degree...