Search results

Premium PL glue. That stuff will hold it in place just fine. (And it will drive your friends crazy trying to figure out whats holding it on!).

Liftmaster is soooooooo quiet and reliable!

I recently did my floor with Epoxy-Coat brand and did color with flakes and next day clear over it all. Clear is the bomb!! I'm sorry I didn't do two coats of clear. I put silver glitter flakes also in an attempt to please my grandaughter. It worked and really gives the floor extra Pop!

Where are you located.

Garage door openers are noisy! I suggest you install Lift Master wall mounted which use Tortion Bars. Quietest I know of. Al W.

Did you folks find a better glove?:beer:

HomeDepot/ $79.00. Works great and hangs from the cieling just fine!

I'm with you! I remember looking at closed garages as a kid and dreaming that a very old car is in need of rescue in there!

Just finished my floor with Epoxy Coat. I had similar problems to yours. Rustoleum makes a two part paste that works great. Easy to work with although you must rough it up as you would any filler. Will do dips and cracks. Al W.

Castrol makes a water soluble cleaner for grease/oil called Super Clean. Should work just fine. Al W.

Rainy days are a No Go in my book. You might successfully apply the first coat but the humidity of a rainy day might cause an unseen moisture to interfere with the bonding or binding with any subsequent coats. Cooler Temps are fine as they give you more time to apply the epoxy as it will slow...

If your finger nail cannot dent it your safe. I put mats down on my Epoxy Coat after a week and all is well. Parked the Yukon on it just an hour ago.

Thanks Rockchucker! One other thought I am adding. Do not use too much Aluminum Oxide, (slipping preventer). A little goes a long way. An even placement of a small amount is just fine. I put it down similar to a heavy amount of chips and it is way too much! Doesn't look bad but I know I could...

The Lift is a chain link, (Bicycle type but much heavier) Lift. The front and rear crossbars which hold/support the Ramps adjust independantly, so I just added a few washers to the front end chain at the top of the tower and that took care of the height difference for the uprights. As for...

I like the Rust Oleum epoxy paste. Fast and sands up great.

I started to. The sides were prepped and I wanted to. The concrete soaked it up like a sponge! Good thing I didn't keep going as I almost ran short of color coat epoxy. My intention now is to ceramic tile it with a complimentary color. Tile is a lot cheaper than epoxy anyway. I want to wash my...

As requested here are a few shots. One thing leads to another and more work in the dress up will begin shortly.

I had a similar problem. My garage is 638 Sq. Ft. and I bought 750 Sq. Ft. of Epoxy Coat. During the roll out of the base color, (Beige), I felt that the transparency of the material caused me to apply it too heavy. Towards the end mix I really had to work hard to roll out the material to get a...

I can't find a way to add attachments. Anyone?

Put down our Epoxy Coat floor coating today. I'm offering a few thoughts. First- Christine you really need better gloves! Second- No one points out how important the relative Temperature at rolling out time is. I waited till Fall so that I would have more time to play out material. Very...