Search results

Search the forum Search Articles
  1. G

    What is this?

    They are small hole gages. Adjust one to a slight drag in a hole you want to know the size of then measure the gage with a micrometer. Jamie
  2. G

    General Air Compressor motor question

    Hi, welcome. 25 rpm is only about a 1-1/2% reduction. I don't think you'll notice the difference in performance. If it's the same frame size it should work just fine. Jamie
  3. G

    Radiant heat install help

    Dah! It's getting late. yea like that. Jamie
  4. G

    Radiant heat install help

    By the way great looking building. Jamie
  5. G

    Radiant heat install help

    Why not let the vertical piece of foam rest against the posts? Jamie
  6. G

    Hello from Indiana

    I'm in Portage. Jamie
  7. G

    Hello from Indiana

    Hi Steve, Welcome to the site. I'm wanting to build a similar building to yours. Did you use Morton in Wanatah? How were they? Jamie
  8. G

    Pole barn post

    He uses a laser to set his poles but a water level is a low cost way to establish a level line. I used a water level while laying the five rows of block for the foundation of my 30 x 36 attached garage. After I was done I checked my work with a transit and it was within 1/4" at the farthest...
  9. G

    Pole barn post

    Hi Cb-man, "blazingnailgun" has several videos on YouTube titled "How to Build a Pole Barn". The first one goes into good detail on how to get the posts at the right height. Jamie
  10. G

    Lowes Kobalt 1-1/4lb hatchet was $18.98 now$4.74

    Hi, all of the stores around here come up $18.98 on line. I may stop in my local Lowes tomorrow just to see. Jamie
  11. G

    Hello from CO

    Hi, welcome to Garage Journal from N. W. Indiana. Jamie
  12. G

    New guy with ?'s

    Hi, I would like to know how the floor in the new Menards is finished. It looks like polished concrete with a sealer. Very smooth but not slippery. Jamie
  13. G

    Automatic Center Punch- Which Brand?

    Hi, I bought a Starrett automatic punch to replace one that I lost. The old one had a replaceable tip, the new one doesn’t. Also the first replacement wasn’t the largest Starrett model. I ended up ordering the bigger one. If I need a lighter mark I just adjust it to suit. Jamie
  14. G

    stubby ratchet

    I didn't even know that I needed a stubby ratchet, now I have one coming. Jamie
  15. G

    I keep getting Logged out??

    Same thing happening to me. Jamie
  16. G

    R8 to Drill chuck

    Alan, There is a great used chuck on Ebay now. Item number 230914126391. This is a Jacobs ball bearing chuck. Jamie
  17. G

    Replacement keys for snap on box?

    Hi, I just received 2 keys for my older Snap On top box from a seller on ebay. They cut them to the number on the lock. Jamie
  18. G

    Easy Scissor Lift Question

    Roll it on a couple of 4 foot pieces of 3/4" black pipe. Jamie
  19. G

    Bandsaw Blades..??

    Hi ozark1, Welcome. The 0.025" thickness blade should work just fine. You may have to adjust the blade guides for the thicker blades. Jamie
  20. G

    ram air compressor

    I have the same compressor. The pump is a Campbell Hausfleld. I bought reed valves for it from Grainger. Same as their Speedair. Jamie
Top Bottom