Search results

Sorry about the lack of pics. It's my mother in laws place and I'm not nearby and getting her to send pics via phone is a challenge. In any case, the floor is flat and the pits cracks and spalling can be fixed with a 2 part/silica and some grinding. I spoke with a contractor who says they do...

Various hairline cracks and patched holes. Polyurea or High quality epoxy?

I am assuming I have about 24 hours to get the epoxy down. Don't see anything on the SDS one way or another

Anybody know how long I need to wait after putting this primer down before laying down the epoxy? Temps in the 60's

Recently had a similar issue with a bad mix ratio. My advice is scrape as much as you can now. Grinding the putty like material that you will have in a week will be the Worst job you can imagine - it was for me.

I had very good luck with Legacy Industrial xtreme 100. Worked very well for pits and spalled areas that I chipped out. You have to work fast using small amounts but it's rock solid when you are done

Have read that this can be done. Any thoughts? If yes, ideas on the thinning ratio? In my case it's epoxy-coat.

On the re-priming, I took the surface down to virgin concrete (had no choice) so there should be plenty of profile. My only concern is that any primer left in the pores from last time might be gone. Does my risk come down to outgassing? - fwiw, I had ZERO fish eyes or pin holes when I put the...

Well, decided to take the bad section up. It's ugly work but after getting underneath the surface layer, I'm glad I did. Very soft. Sort of like a rubbery putty. Using a diamabrush coating removal wheel on my grinder. Will probably use some acetone or other stripper (suggestions?) to get some...

What the heck are PCD units?

I've got some of the original color base left over, plus I will put the heavy flake down so I am less co cerned about color amd more about being level with the existing surface

Tried all of that already...... IF it has to come up (I'm leaning that way) any recommendations on the best way? It's a 10x10 section at the garage entrance and against one wall so I have 2 side that flow to "good sections". So 1) what is the best way to take it up? 2) how to re-prep the...

Left it alone. After 5 days I'd say it's about 90% as hard as the properly mixed sections.

Looking at your site. Which brush do you recommend? 120?

Thank you sir. Helpful as usual

Thank you sir. Helpful as usual.

Clear is 2 part epoxy. Thanks for the help

I do have a 2 part clear already which I put on over the flakes to at least 10 mil. Does that make a difference? If not, it was just an idea for one more layer. Will be fine if I can't add the urathane

Occurred to me to do this just now as the floor is in and I have not ordered the product. What is the prep?

Any thoughts on time from epoxy installation? Any special prep for a floor with heavy flake and 2 part clear over the color layer?