Search results

I’m building a new house and detached garage. When the builder/concrete contractor poured the basement floors and slab for the detached garage, they used a 1315 cure and seal. Any issues with going over that with Ghostshield 9500? Thanks

No, I'm only out the money for a couple fittings. So, it's not worth my time. I thought I'd start with a couple and see how they do and perhaps switch the whole shop over to them. So, they've served that purpose, and the cost is negligible based on the amount of business we do and volume of...

Based upon this thread, I tried a couple Stedlin fittings for our shop (professional automotive repair shop). One didn't last six months and recently cam apart while one of out technicians was using it. Luckily, nobody was injured and no cars were damaged. Based upon the short life span and...

We use shopware. I’ve seen competitors using tekmetric and it looks good too.

Have thought about putting a shop on some land with a small apartatone end and came up with this.

You might also look into Odor Bombs or similarly chlorinated ones. You set them off in an empty car and come back the next days. I’ve used them with good results for cars that were smoked in.

https://www.mytoolequipmentguy.com/bendpak-grandprix-gp-7lc-low-ceiling-height-118-5/ There are clear floor lifts designed for low ceilings.

I’ve mounted quite a few things on my 2 post lift. In every instance, I welded a bracket to the post and then drilled that. Was usually much easier because I could creat the bracket and drill holes prior to mounting anything. Also, drilling holes was much easier using thinner metal.

Use Rustoleum hammered paint. Minimal prep and hides everything. I’ve used it for rusty shop shelves with great results. Just scuff it, knock off any loose stuff and roller brush on. It flattens really well too.

I have a Dewalt that I like. It seemed like a good compromise between the super cheap ones and the expensive ones like cox. The colors also matched my dannmar lift that I mounted it on.

Copper for my cooler into my filters then into a RapidAir system.

Here’s mine an old Curtis Toledo from the 1950’s. Works great. Will fill the 80 gallon tank from empty to 155 psi in six minutes. I recently repainted it with ford blue tractor paint.

From the video, it looks like a 60 gallon vertical and the weld on the bottom of the tank gave out.

Almost never unless doing a really messy job like a cv boot replacement and regressing the joint.

It’s about amp hours. You get more amp hours with 6 8v batteries. So, they don’t discharge as quickly and they give you more range. That also contributes to them lasting longer and having to replace them less frequently. As a result, it’s not uncommon for people to convert a golf cart to 6 8v...

If you want a lift, there are low rise lift and scissor lifts that are options that would work with a 9-10’ ceiling. You should probably research those and build with your lift in mind. Also, most lifts only require 4” of concrete although more is better. Look at the manufacturer’s specs for...

6 mil polyethylene is the standard for vapor barriers. If I were the contractor and had done this dozens of times successfully and had a client trying to tell me how to do my job, I would probably fire the client.

I also like the Rustoleum hammered paint for rough surfaces. It tough paint and hides lots of imperfections

Quick update. I painted this Ford tractor blue with Rustoleum hammered silver accents.

The OP might be better off putting the pool on the ground and building a deck around it + building deck inserts/platforms that could be put on/into the deck when the pool is remov d for the winter.