Search results

I have an old General table saw that has a Walker Turner KAB-10e 1HP 110/220V 15.4/7.7A Single phase 125A Frame Motor. It is currently wired for 220V. I tried to run it and it hums... I checked the start capacitor, and it was bad. I replaced the start capacitor with the same size. and tried...

I meant quarter turns... My shaft center is 129.5" so my cable should be 129.5"+63"-21"( highlift)=171.5" (I have 400-54 drums) Now with my 100lb door, what is the ideal spring or springs to install?

Thanks Andy. Where does one find these calculations? I have a 400-54 drum, 8ft door, 21" lift what should the cable length be?

I have 1/2 wrap. I don't recall what I meant by adjusting.... to be closer to the floor... I will remove it from the original post

Spring is here, and I am back on this. Sorry for the delay, for some reason I didn't get any notifications of responses. I have an 9ftx8ft door, stanley, steel weighs 100lbs I have two 400-54 drums, cable length is 11ft 4". I have raised the track 21" from where it was previously. 15" radius I...

Hi All, I have a 8ft door in a 11 ft high garage... I wanted to raise the door to accommodate a 2 post lift. It was a cheap Stanley uninsulated steel door with a single spring. I got track and bracket, large capacity drums, longer cables, and two 225 springs... Track moved and modified to go...

Thanks, I will measure a link tomorrow

I'm looking for the chain size for a Craftsman Opener...I want to repurpose it for another project and need to spec out another sprocket.... Thanks, Rob

Inadvertent post.