12 flexible bit holder stuck in drill

[BigShotBob]

It's stuck in there pretty good. Need help

Tried putting it in reverse, pulling, using dykes, hitting it, all nothing. Have no WD40

 

[relicrecoveryspecialist]

Use pliers on the chuck, try to turn it on just a tad, and pull out and then push backwards. Sometimes newer drills do that. I’ve had two Matco’s like that, and had to have the Matco guy come get them unstuck just in case I broke it. You may hold a pair of pliers on the chuck, and hit the plier head where it pops it loose


Sent from my iPhone using Tapatalk

 

[cstmg8]

Looks like an impact? That bit is probably too soft. Did you hold the bit firmly (like not letting it turn at all) while you reversed it? Sounds like it just jammed/wedged.

Sent from my Pixel 3 XL using Tapatalk

 

[snyder]

I'm pretty sure that's not a drill chuck. Try pushing in the quick disconnect outer ring.

 

[relicrecoveryspecialist]

I'm pretty sure that's not a drill chuck. Try pushing in the quick disconnect outer ring.

That’s what I meant as a chuck, quick disconnect just push it in, I’ve used pliers to lay over the top and tapped it on the pliers and got it loose


Sent from my iPhone using Tapatalk

 

[cderalow]

Pull up on the knurled ring.

At least that’s how my ryobi works.


Sent from my iPhone using Tapatalk

 

[tarbellb]

Ive had a bit get stuck in my older M12 Fuel impact to the point that I sent it in for warranty.

Short of breaking it, I tried everything.