Adding leverage arm to motorcycle stand

[TheClaw]

I'm looking for ideas to attach, on a temporary basis, an additional leverage handle on a motorcycle lift.

The lift I have is pretty cool. It helps me spin a bike around inside the garage. However, it's a little short and on my heavier kawasaki it takes a lot of heft to tilt it up and at the same time balance the bike.

I'm not a welder so I'm looking for a solution that provides the mechanical leverage I need and is removable.

The pictures show the stand with the bar from my Jack wedged in some of the corners. Anyway I can attach this with parts and bits from the home Depot?

The Pitbull stand is shown as an example. It's the red lift that I need to work on.

 

[Lassen Forge]

Slide over iron pipe cheater bar on the handle.

 

[kngelv]

The small wheels on that rear stand are your main issue. Just get another Pit Bull for the rear.

James

 

[imagineer]

Do you have a crow bar? Slip the hook end in the opening inside the loop and under the cross bar (where the "Grand Pit Stop" label is).

 

[TheClaw]

Do you have a crow bar? Slip the hook end in the opening inside the loop and under the cross bar (where the "Grand Pit Stop" label is).

That's a good idea. I thought flattening the end of an iron pipe then drilling thru the label and cross member so i secure it with a pin. What i don't want happening is the bar slips off to the side and then the whole thing topples over.

 

[driftpin]

CONDOR Motorcycle Garage Dolly

Simply push any motorcycle onto the Garage Dolly, and into our Condor® Wheel Chock, with its patented adjustable cradle that accommodates every type of motorcycle. Now your bike is secured in an upright position, and is ready to be easily rolled, or swiveled anywhere you wish in your garage to...

www.condor-lift.com

Condor roller dolly



Yes it's costly, but easy to load/offload, and to roll-about. Watch the video.

The New Expandable Condor® Motorcycle Garage Dolly
Simply push any motorcycle onto the Garage Dolly and into the Condor® Wheel Chock. Its patented adjustable cradle accommodates every type of motorcycle — from heavy cruisers and touring bikes to sport bikes and dirt bikes — with wheel sizes from 13″ to 30″. Once secured in an upright position, your bike can be easily rolled, swiveled, or pushed anywhere in your garage for storing, servicing, detailing, or simply keeping it safe and out of the way.
The Garage Dolly rides on sturdy 4-inch wheels that navigate cracks, crevices, and uneven garage floors with ease. Built from durable aluminum and steel, it weighs just 68 lbs and supports up to 1,300 lbs. It measures 90″ long (expandable to 94″) with a 12″ wide deck and 24″ at its widest point at the wheel brackets. Four large twist-down brakes keep the unit firmly in place while loading or unloading your bike. When not in use, the Dolly folds flat and can be wall-mounted for storage.
The Garage Dolly includes a Velcro Security Strap (Part# VS-Black). The following add-on accessories are available separately: Supplemental Ramps (Part# GD-RAMP1-ASM and Part# L-PB35-C), Extensions (Part# GD-EXTEND), and Height Assist (Part# GD-H-ASSIST-KIT).
Proudly made by Condor® in America.

 

[M.Brane]

I just got one of these: https://abbastandsusa.com/product-detail.asp?item=sky-lift&pid=44