Armorpoxy floor issue

[tweidman]

About a year after putting down my Armorpoxy floor I am starting to get some lifting where I park. I went out of my way to follow the directions and clean the floor, so I'm not sure what went wrong. Has anyone successfully repaired something like this? Or, will it continue to lift where ever I park?
I sure hope I don't have to start over with my floor?

 

[DWAS]

Just curious, did you start with a primer layer. I just started my own Armorproxy project this morning (primer layer) so your post caught my attention

 

[perkinscl]

Why don't you reach directly to Armorpoxy? Did you grind or profile the floor prior to the epoxy?

 

[tdott]

Did you acid etch or grind?

 

[tweidman]

This was a brand new concrete floor. I pressure washed it and then etched it.
I did not use the primer, as I did not think it would be necessary.
I documented some of the steps in my build thread. Post #73, page 4
https://www.garagejournal.com/forum/showthread.php?t=309274

 

[02vito]

In my previous shop, I etched and two-part epoxied the floor. The sticky tires on my race car would lift the paint where the car was parked for any length of time. This was more than 30 years ago, so the two-part floor coatings have probably improved since then.

In my new shop I am not planning on using a two-part coating.

 

[Armorpoxy]

PM sent, thanks.

 

[tweidman]

PM sent, thanks.

Thank you