You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Beacon Morris 45k issue
- Thread starter Kamp_92
- Start date
finn
Well-known member
I have two 75k BM heaters in different buildings.
One makes noise on startup, the other doesn’t.
The one that makes noise has a couple of elbows in the horizontal vent pipe to line up with the hole through the wall. The quiet one ic straight out (almost) the wall.
One makes noise on startup, the other doesn’t.
The one that makes noise has a couple of elbows in the horizontal vent pipe to line up with the hole through the wall. The quiet one ic straight out (almost) the wall.
I have 2 elbows for my horizontal pipe too. I won’t worry about the noise then.
Also are they supposed to shut off say after an hour of continuous running for a few minutes? I didn’t think to look at the manual / led trouble code light last night. But the garage was cold (45) and I turned it to 65 and after roughly an hour it shut off for a few minutes and turned back on. Thermostat was not up to temp yet. Think I was about 60 when it did it.
Also are they supposed to shut off say after an hour of continuous running for a few minutes? I didn’t think to look at the manual / led trouble code light last night. But the garage was cold (45) and I turned it to 65 and after roughly an hour it shut off for a few minutes and turned back on. Thermostat was not up to temp yet. Think I was about 60 when it did it.
dfiler2
Well-known member
My 75K does the same thing, I did ask a professional about it and I can't remember the reason but he wasn't concerned about it. It's been in for two full winters and this one, so far no issues.