gmoscajl969
New member
- Joined
- Nov 25, 2017
- Messages
- 1
Ceg single phase 230v motor need help
- Thread starter gmoscajl969
- Start date
rockwithjason
Well-known member
The pics arent clear enough for me to read but that is iec nomenclature. Do a google search for iec motor reconnection diagrams and you will find what you need
wyliesdiesels
Well-known member
Looks like that is 5HP, so it must be hardwired unless you use pin and sleeve receptacle and plug.
It is a Permanent Split Capacitor (PSC) Motor.
It has a squirrel cage rotor and a stator. The stator has two windings – main and auxiliary winding. It has a capacitor hard-wired in series with the “start” winding. There is no centrifugal switch.
5 Hp = 3.7 KW
1690 RPM (4 pole)
230VAC, 60HZ = Rated voltage (95 – 105% rated voltage = rated output)
19.6A = Full Load Amps at rated output
Class F insulation = Insulation Temp Rise = 100C
Ser.S = 1 (Duty Cycle – S1 means continuous duty and Service Factor is only 1.0)
IP 55 ~ Dust tight, Protected from water jets
Power factor ~ 0.9
Capacitor = 70 micro Farad, Voltage rating = 460 VAC
Motor size (frame size) = 112
Anlauf = “Start” winding (determines direction of rotation)
Betrieb = Run winding
No mention of overload protection. Should install something.
It has a squirrel cage rotor and a stator. The stator has two windings – main and auxiliary winding. It has a capacitor hard-wired in series with the “start” winding. There is no centrifugal switch.
5 Hp = 3.7 KW
1690 RPM (4 pole)
230VAC, 60HZ = Rated voltage (95 – 105% rated voltage = rated output)
19.6A = Full Load Amps at rated output
Class F insulation = Insulation Temp Rise = 100C
Ser.S = 1 (Duty Cycle – S1 means continuous duty and Service Factor is only 1.0)
IP 55 ~ Dust tight, Protected from water jets
Power factor ~ 0.9
Capacitor = 70 micro Farad, Voltage rating = 460 VAC
Motor size (frame size) = 112
Anlauf = “Start” winding (determines direction of rotation)
Betrieb = Run winding
No mention of overload protection. Should install something.