Clean-up question … turpentine

[Old tool guy]

I'm using this product to apply a japan finish to some tools. The label says to use turpentine for clean-up. Actually it says to remove the varnish, I’m assuming that’s the same thing. I don’t have turpentine, tried using acetone, doesn’t come off my hands easily. Probably should have worn gloves. What else could i try?

 

[Shiftless]

I agree that nitrile gloves would have been a good idea.

Now that that black goop is on your fingers, I suggest trying WD-40

 

[PCustoms]

Google says paint thinner

 

[BillK]

I'm using this product to apply a japan finish to some tools. The label says to use turpentine for clean-up. Actually it says to remove the varnish, I’m assuming that’s the same thing. I don’t have turpentine, tried using acetone, doesn’t come off my hands easily. Probably should have worn gloves. What else could i try?

Turpentine ??? Paint thinner is basically the same thing but better if you have any of that.

 

[pcmeiners]

Turpentine warning.... Do not use this as a cleaner, if it gets on rags, saw dust or other materials which support combustion it can cause a spontaneous combustion fire, my mom's house nearly burn down due to drop cloths which had turpentine on them.

 

[PCustoms]

Turpentine warning.... Do not use this as a cleaner, if it gets on rags, saw dust or other materials which support combustion it may can cause a spontaneous combustion fire, my mom's house nearly burn down due to drop cloths which had turpentine on them.

I believe the same would apply to the finish the op is using as well.

Or any oil-based stain/wipe product for that matter.

 

[Dagny]

Diesel gas kerosene. I have lots of tarhead buddies and thats what they use for asphalt.

 

[Shiftless]

Old tool guy:

By now, you must have tried one of our suggestions. Did something work for you or ???

Hopefully you didn’t go with the gasoline suggestion and try it while standing near your water heater.

 

[545_days]

I believe the same would apply to the finish the op is using as well.

Or any oil-based stain/wipe product for that matter.

I am a big fan of burning rags soaked with boiled linseed oil, varnish, etc. in a controlled manner before they can spontaneously combust in an uncontrolled manner.

Of course I also live somewhere where I can get away with that

 

[PCustoms]

I am a big fan of burning rags soaked with boiled linseed oil, varnish, etc. in a controlled manner before they can spontaneously combust in an uncontrolled manner.

Of course I also live somewhere where I can get away with that

I sprayed some paint this morning thinned with acetone.

Had 3-4 rags and some "paint" left it a paper cup after cleanup, threw it in the pit and tossed a lit paper towel core at it.

****.

 

[larry4406]

At the day job I’ve gotten tar on my hands.

I used the spray start on a rag to scrub it off my hands. Wasn’t the best solution, but all I had at the time. Stuff really dries out your skin and I’m sure not recommended.

 

[Old tool guy]

At the day job I’ve gotten tar on my hands.

I used the spray start on a rag to scrub it off my hands. Wasn’t the best solution, but all I had at the time. Stuff really dries out your skin and I’m sure not recommended.

If your house is like mine, there are at least 18 tubes and pump bottles of hand lotion scattered about, variety of scents, all claiming to “fix” your deficient skin.

 

[Old tool guy]

Turpentine ??? Paint thinner is basically the same thing but better if you have any of that.

Turp … yep, that’s what the label calls for.

Tried paint thinner, came right off.

 

[PCustoms]

Turp … yep, that’s what the label calls for.

Tried paint thinner, came right off.

As mentioned above I sprayed this morning. Was a good boy and wore my respirator. What I didn't do was clip the beard short like I normally do.

Been outside all morning, went in for some lunch and looked in the mirror.

Any tips for removing dried red Rust-Oleum from around your mouth? Hoping a shave and lava soap helps, otherwise I'm in for some awkward meetings tomorrow...

 

[Stuart in MN]

Turpentine warning.... Do not use this as a cleaner, if it gets on rags, saw dust or other materials which support combustion it can cause a spontaneous combustion fire, my mom's house nearly burn down due to drop cloths which had turpentine on them.

Turpentine is fine to use, you just have to dispose of any rags properly. Burn them, or put them in a bucket of water, or lay them out on the ground where they can dry out safely.

 

[Just_Steve]

When I did roofing back in the day we used Lestoill to remove roofing tar from hands and tools. Don't spill it in your driveway.

 

[Milton Shaw]

I use WD 40 to remove oil base paint. Safe for hands and works great. Just spray a little on hands and wipe off with paper towels. The other reason is just about every home has some without having to buy some acetone or paint thinner.

 

[Old tool guy]

I use WD 40 to remove oil base paint. Safe for hands and works great. Just spray a little on hands and wipe off with paper towels. The other reason is just about every home has some without having to buy some acetone or paint thinner.

Hah. I have acetone, mineral spirits, brush cleaner, brake cleaner, engine degreaser, tsp and liquid sandpaper, but no wd-40.