Found this on CL for $20. Owner says it is rusty and the chuck wobbles. I've never tried restoring anything like this. I'm not worried about the rust but not sure about the chuck being wobbly. I figure for $20 I would give it a shot. Is it worth the effort?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Craftsman drill press advice
- Thread starter WWShop
- Start date
454ragtop
Well-known member
I'm personally not a huge fan of Craftsman drill presses, but you'll never get hurt for $20., that table is worth more than that. Chuck wobble could be a bent spindle, bad bearings, or bad chuck, all of which should be repairable with varying amounts of effort.
Good luck, Jim
Good luck, Jim
Eh, depends on how bad the chuck wobble is. If it needs a spindle, I'd pass. Parts and hassle is going to be a wash vs buying a more expensive machine from the get go. Med sized drill presses ain't exactly rare on the used market. If you are up for a project, go for it, just realize long term to get a good drill press it might not be the quickest, easiest or cheapest solution.
I'm supposed to pick it up today. I asked the owner for a model number but he didn't get back to me about one. Anyone possibly recognize this particular model? Anyway, I don't need a drill press immediately so if it takes time to repair then that is ok. I like my tools and equipment to be USA made if that is possible. I'm hoping/assuming that this one is but I'm not entirely sure.
HoosierBuddy
Well-known member
My bench top Craftsman drill press chuck has always wobbled. I think it's a characteristic of the machine.
Phil
Phil
I like my tools and equipment to be USA made if that is possible. I'm hoping/assuming that this one is but I'm not entirely sure.
The handle knobs, switches, and chuck sure look like US-made