Design for Rotating Tool Stand on Casters

[Jayhawk_Aviator]

Im wanting to make a tool stand for my drill press, two bench sanders, and bench grinder. Im envisioning it being squarish, with 1 of the 4 tools at each corner. I'd like to make it out of square tubing and put casters on the bottom so I can roll it out of the way.

Curious if anyone has done something similar and has design ideas to shaare?

Thanks,
Scott

 

[cvairwerks]

Take a look over on the Vans AirForce site. Couple of guys over there have done them, but in wood, not steel.

 

[Kaizen]

I like the idea of having it movable so long lengths don’t it the walls


Sent from my iPhone using Tapatalk

 

[Jayhawk_Aviator]

Nobody has one of these?

 

[Modern Garage]

I like this carousel/lazy susan design. What are you using for support of the turntables? There will be some weight there and stability will be needed. I can see something under the corners of the bottom turntable but can't tell if there are bearings there.
Since you say you're working on it now, is this a pic from another project or someone else's plan?
Joe

 

[Motorman55]

Looks similar if not the same to this plan...