To avoid these ads, REGISTER NOW!

Grind or not?

S

Sasquatch912

Well-known member
Joined
Nov 2, 2016
Messages
362
Location
Georgia
Wondering if I need to grind my concrete down to remove bumps (where we were dragging the concrete to smooth it out when we poured it), etc. The slab is 30x30 and does have a few low spots.

If I do need to grind them what diamond grit?

Any suggestions?
 
To avoid these ads, REGISTER NOW!
L

LegacyIndustrial

ALLIANCE MEMBER
Joined
Jun 7, 2010
Messages
7,994
Location
deerfield, IL
Unless you are going to polish this floor to at least 400 grit, that floor is going to be a dirt trap with just a densifier on it.

An epoxy sealer would be a better bet once you grind.
 
OP
S

Sasquatch912

Well-known member
Joined
Nov 2, 2016
Messages
362
Location
Georgia
LegacyIndustrial said:
Unless you are going to polish this floor to at least 400 grit, that floor is going to be a dirt trap with just a densifier on it.

An epoxy sealer would be a better bet once you grind.
Click to expand...

I was going to do the densifier and that ghost shield like you recommended due to oil spills, etc. So dirt will be an issue?

Im just unsure about epoxy at the moment since i will be welding and stuff.
 
To avoid these ads, REGISTER NOW!
You must log in or register to reply here.
To avoid these ads, REGISTER NOW!
Top Bottom