Grinding JB Plastic Weld

[ukiltmybrutha]

I have to grind some JB Weld off of a bumper ridge and the clearances are relatively tight. I have a dremel tool but wasn't sure what the right bit for that might be? I'd just try anything but the bumper is rather rare.

Any ideas?

Thanks.

 

[tarmy]

How about a fine grit 2” wheel on a right angle die grinder...that is where I would start...with the speed set as low as possible...

 

[subroc]

I just filled some holes using JB weld. The 2 holes that were on the flat surface I used a ROS with the dull sand paper that was in the thing. On the profile surface I used the ROS with the same dull paper and hand sanded with some folded 120 grit. It comes of reasonably fast. Seems a bit harder to sand than say, some bondo filler. But, not by much.

Good luck

 

[ukiltmybrutha]

Thanks all.