hacksaws?

[jbltwin1]

Little mini saw that I use a lot. WAS my dads, now mine, and I'M 71. Couldn't find blades the right size. Everything I found was too long by about a quarter inch so I mig welded in a section to use standard blades.

 

[four.cycle]

Union Hardware Co., Torrington, Connecticut No. 10 hackwaw

* this saw is missing the original wing nut *

 

[59Sled]

Picked this Eclipse no.55 saw today. Only bought it because how odd it was. Strange that it has a hacksaw blade on the bottom but is like the size of a coping saw. Also not sure the age of it

 

[nigelrudtbandit]

That’s a Sheet metal saw! I’ve several of these form my dads tools

 

[RTM]

From the 1969 catalog

 

[disston]

Nice find. Never seen one of those before.

 

[59Sled]

couple of before and afters of some saws I cleaned up.

 

[59Sled]

Before and after of Eclipse I just recently got.

 

[Eric Brown]

Before and after of Eclipse I just recently got.

Looks really good.

 

[59Sled]

Picked up this Great Neck no.75 Jab saw to restore.

 

[Old tool guy]

Before and after of Eclipse I just recently got.

How did you get the handle so shiny.

 

[59Sled]

How did you get the handle so shiny.

I lightly sanded the rust off with a red scotch brite pad.Then I use foam backed polishing pads. The pads are 2 inch by 2 inch squares and starts at 320 grit all the way up to 3500 grit. I start with 320 and cont up to 3500; after that I take it to a buffer wheel.

 

[Beerhippie]

Picked up this Great Neck no.75 Jab saw to restore.

Be careful--that can lead to drywall work!

 

[59Sled]

Picked up this Great Neck no.75 Jab saw to restore.

Didn't take to long to clean this one up.
Filed off the casting lines that ran around the outside and inside perimeter of the handle. Sanded and a quick polish.

 

[Eric Brown]

Didn't take to long to clean this one up.
Filed off the casting lines that ran around the outside and inside perimeter of the handle. Sanded and a quick polish.

Looks nice.