To avoid these ads, REGISTER NOW!

Help ID a part or modern replacement

A

antman213

Well-known member
Joined
Nov 19, 2017
Messages
328
I have a few old power tools with what I am calling a "Brass Vent Plug". I would like to get some replacements on a refurb I am doing but am not having much luck even finding reference on these. I have some pictures attached for reference.Does anyone know where to get these or a possible modern alternative?



20220304_020010.jpg
20220304_020048-jpg.1686569
 

Attachments

  • 20220304_020048.jpg
    20220304_020048.jpg
    238.2 KB · Views: 148
To avoid these ads, REGISTER NOW!
R

RTM

Well-known member
Joined
May 13, 2019
Messages
13,238
Location
SF Bay Area
antman213 said:
I have a few old power tools with what I am calling a "Brass Vent Plug".



20220304_020048-jpg.1686569
Click to expand...
Talking about the one hidden by the handle, correct?

Never seen something like that before. Could you build it out of a bushing and some fine brass screen
 
OP
A

antman213

Well-known member
Joined
Nov 19, 2017
Messages
328
RTM said:
Talking about the one hidden by the handle, correct?

Never seen something like that before. Could you build it out of a bushing and some fine brass screen
Click to expand...
RTM, yes it appears to be a screen or vent made of brass. I've actually seen quite a few in older corded tools. In this case its in a Portomag mag drill base but I also have them in a B&D "Holgun" .

I was considering trying to replicate but I'm not sure what would be the best way to go about it since they are fairly thin. Not to mention brazing screen would be a real PITA
 
To avoid these ads, REGISTER NOW!
OP
A

antman213

Well-known member
Joined
Nov 19, 2017
Messages
328
Thanks for the suggestions, I think the cigar grommet may work just need to check the OD of the hole. I would have never thought to look that up lol. The snap in panel screens may work aswell
 
You must log in or register to reply here.
To avoid these ads, REGISTER NOW!
Top Bottom