You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
How to remove Snap-On tool box handle?
- Thread starter jswilke
- Start date
rodknocker
Well-known member
On the chrome outer pieces there are bolts under the snap on logos
2fat2fly
Well-known member
On the chrome outer pieces there are bolts under the snap on logos
+1
Rodnocker is right. You'll need an Allen wrench to remove them. Peel the outside corner up on the Snap On decals with a small screwdriver to expose the bolts.
On the chrome outer pieces there are bolts under the snap on logos
Thanks for the lightning fast response, rodknocker! I removed a drawer looking for bolts on the inside of the cabinet; no wonder I could find none.
I plan to R & R the handle and casters to reverse everything so tool cabinet will fit against wall...I need all the room I can get to fit the huge box in limited space.
Last edited:
conceptzj
Active member
I need some parts off that handle, since you are not using it, would it be for sale? Just PM if it is. Thanks.
I need some parts off that handle, since you are not using it, would it be for sale? Just PM if it is. Thanks.
Thanks anyway, but I prefer to keep the handle for the next owner some day when I sell the tool box. The only reason I removed the handle was to be able to park a refrigerator right next to the handle side of the tool box.