Impact wrench

[Elvie84]

Hi everyone I have a 1/2 brushless impact wrench and was wondering would it be powerful enough to put a 3/4 adapter and socket on it or would it be sluggish ?

 

[Farmall450]

Really depends what you're using it on. Which impact do you have? The top of the line DeWalt XR/M18 Fuel are pretty peppy, maybe even compared to older air 3/4 guns, especially on homegamer 3/8 lines.

 

[Elvie84]

It’s a Ozito brushless it has a bit of torque but didn’t want to burn it out

 

[Mgdoug3]

I use the high torque Milwaukee with a 3/4" adapter occasionally. It will take the lug nuts off a semi.

 

[DFB]

Ya I often wap wap wap the Milwaukee 1/2" high torgue with 3/4" drive sockets and adapter...

Whats an Ozito???

 

[Farmall450]

Ya I often wap wap wap the Milwaukee 1/2" high torgue with 3/4" drive sockets and adapter...

Whats an Ozito???

Yeah, that's a new one for me, too.

OP, only one way to find out, give it a try. You won't hurt the impact.

 

[Elvie84]

this is the ozito

 

[Farmall450]

Ah, Australian brand. Give her a whirl. Looks like a mid torque, though.

 

[FSrepair&fabrication]

If youre trying to break it loose, hook it up and try it out! If youre tightening, crank it down and check it with a torque wrench to see if its tight enough. In my experience, most 1/2 battery guns can handle a 1 5/8” and down 3/4dr socket in short spurts. Continuous hammeriing seems to heat them up quickly and kill the battery. It all depends on what youre trying to do with it

 

[DFB]

this is the ozito

Kewl!