In wall airline ?

[tuip]

Getting closer to putting insulation and sheetrock on my garage build and I'm hoping to get the compressor mounted in a more enclosed area and run a fixed line through the trusses towards an air reel mounted to the ceiling.

I've seen 2 choices .. some suggest simply using galvanized water pipes for the run .. others suggest a regular airline like this kit.

http://www.amazon.com/Rapidair-90500-Master-2-Inch-100-Feet/dp/B0015A11U2/ref=sr_1_4?ie=UTF8&qid=1448062782&sr=8-4&keywords=in+wall+air+line#Ask

What are the suggestions from those that have done this before?

 

[kd3pc]

the risk of the rapid style line, is that it can still be punctured, if you run a screw or nail through it, or if a fitting or joint needs repair, it may be behind the finish. If you can get it away from hazards...., but running it through a 2x (you should not drill trusses) attached to the truss - you might be OK

black iron would be the best, but with threading and such, the design and install are more important, but it will last a lifetime.

 

[S4cruiser]

I went with the rapid air system and mounted in the wall. I did put nail plates to mitigate the risk of puncturing.

I've been very pleased so far.

 

[mg283680]

The metal pipe offers a bit of cooling to the hot air. Plastic, no.
Its not good news, but for air, you need to think starting what you want to do, then work back, build a system and get a compressor. A 30 gal system is not going to cut it if you want to run anything that spins.
Buying used and DYI you can drop a lot on compressor, air system, and tools.
Compressor: Slow motor, 175PSI
System: 3/4" pipe, dryer, filter, regulator, hose
Tools: Your choice