Inexpensive adjustable pressure switch for air compressor?

[goodysgotacuda]

I have a Charge AirPro compressor [20gal, 9.4scfm @ 90psi; 220v] that has a static pressure switch that I find annoying. It runs up to 125psi like a good switch, but it doesn't seem to kick back on until ~85psi or so...which is a bit low for me.

I run my air tools as max psi and at 85psi or so..they don't do what I want, with that huge pump on a little tank, I'd like to kick it back on at ~100psi.

Any suggestions for a 220v adjustable pressure switch that doesn't break the bank? I don't deal with much a/c electrical, so I'm a bit lacking in my wiring knowledge when it comes to that...hopefully just a swap terminals kinda deal.

Thanks!

 

[Jbullfrog]

Get a bigger tank. Pressure switches are not something for a novice to start tinkering with. You can cause alot of damage or get hurt.

 

[PT Doc]

Condor makes pressure switches that are used by Quincy. I'm sure you can find what you want from a place like Graingers.

 

[AE2]

Square D

 

[dirtydogintex]

Square D or Furnas.

I'm rigging a duplex setup w/Square D (Pumptrol(?)) adjustable dead band PS's.
I'll try to post the Square D/Grainger model nos later.