Kent Moore J-1928-01 Tool ID Needed

[r_olson_06]

I found this Kent Moore J-1928-01. The socket side appears to be 15/16" 12 Point. Any ideas on what the purpose of the tool is. The guy who's estate i bought it from fixed IH tractors.

 

[RoninB4]

Any ideas on what the purpose of the tool is.

-Looks similar to an offset distributor clamp wrench. Purpose would be for the "reach around" and likely for a specific tractor. It's a somewhat generic type of wrench for when you don't have clear access to the fastener.

 

[yhprum]

I’ve seen similar tools for tightening down cylinder base nuts on large radial aircraft engines.

 

[r_olson_06]

-Looks similar to an offset distributor clamp wrench. Purpose would be for the "reach around" and likely for a specific tractor. It's a somewhat generic type of wrench for when you don't have clear access to the fastener.

Thanks you. I was checking online and have not seen any this large before.

 

[r_olson_06]

I’ve seen similar tools for tightening down cylinder base nuts on large radial aircraft engines.

Thank you!

 

[3baygarage]

The Bonney I have were torque adapters for cylinder head nuts. The largest being 3/4”.

You might find something comparable under Snap-On or OTC.

 

[RoninB4]

Thanks you. I was checking online and have not seen any this large before.

-Some other members have posted applications where a more robust wrench was needed. I'd favor those postings over my suggestion of a distributor wrench.