Anti grease zerk? How's come?Slummin today with my lowly BJP1....
Matco BJ tool is a beast....
- Thread starter Buckgnarly
- Start date
kbeefy
Well-known member
No Zerk. I just had one of these fail due to galling so I painted some antiseize on this one.
2ndGearRubber
Well-known member
Moly grease has always been my preference, has stopped thread damage on any of my pullers/presses.
We've discussed this a lot. Moly grease is the best for high pressure screw lubrication- this is what ARP gives you in the little pouches; or they used to. The problem with the tubs of moly grease is it can have 1% moly in it, and they will call it a moly grease. I use the below. It's expensive, but a container will last most of us a lifetime. It's also what you should use on splined driveshafts.
Loctite 234227 LOC51048 Moly Paste Anti-Seize Compound: Amazon.com: Industrial & Scientific
Loctite 234227 LOC51048 Moly Paste Anti-Seize Compound: Amazon.com: Industrial & Scientific
www.amazon.com
There's a spot for a zerk, did yours not come with one or what?
kbeefy
Well-known member
It did not. It was a warranty replacement, so maybe they were supposed to swap it off the old one.
I have a drawer of spare fitting should I want to put one in.
I have a drawer of spare fitting should I want to put one in.
It is a beast. Have only used it one time on a mid 2000s 2500HD GMC. Was awkward pushing out (hammer would have been faster) Easy breezy press in. Bad example; my old OTC could have handled easily.milky2k
Well-known member
They make a tool for that?