Mr. Heater question.

[swaterbenny]

I got my 80,000 btu heater fired up, and I feel like the flames are a little too yellow from other post I read on here, just looking for opinions. The last photo is from the first time I fired it up, yesterday. Thanks Ben

 

[mm08822]

Last photo probably the result of initial purging of air in fuel line.

Pic #2 looks fine.

What is your supply pressure while running?

 

[bobbyjean]

10.41 while running ...flame looks good..is it throwing a code or are you just concerend about flame? check your safeties to make sure they work and call it complete.

 

[mm08822]

10.41 while running ...flame looks good..is it throwing a code or are you just concerend about flame? check your safeties to make sure they work and call it complete.

10.41 is the manifold pressure. Question is about supply pressure.

 

[swaterbenny]

I just read that there should be a strong blue flame with very little yellow, and that's what I'm questioning. I have a lot of blue, but the tip has a share of yellow to it. When I first started it for the first time it was mostly yellow, now after running for a while its settled down. Honestly I think it's good to go just looking for other opinions.

Here is a picture of the supply pressure at 11.40.

Thanks, Ben

 

[mm08822]

Not the same as being there and seeing it but flame in pic looks good.

I think you're done.

 

[swaterbenny]

Thanks for the confirming my thoughts. Ben