To avoid these ads, REGISTER NOW!

Need some tape for the engine bay

larryq

Well-known member
Joined
Jul 12, 2011
Messages
2,421
I had to install some new rear brake lines on my car, and previously when they threaded up and into the engine bay they were connected with a rubber triangle/grommet against the firewall so as not to rub against the steel.

They were taped into place in the grommet, and I need to re-tape. The prior tape was a kind of mixture of electrical on the outside and cloth on the inside; any recommendations on what to use here?
 
To avoid these ads, REGISTER NOW!
To avoid these ads, REGISTER NOW!

garagelogician

Well-known member
Joined
Jan 27, 2016
Messages
453
Location
Blaine, MN

theoldwizard1

Well-known member
Joined
Feb 22, 2011
Messages
43,389
Location
SE MI
If it is going to rub, it is going to wear. Only a matter of how fast !

I had some A/C lines that were clamped to a frame rail. I cut a piece of heater hose, slit it and placed it over the A/C line. That will take a LONG time to wear through !
 

Squankum

Well-known member
Joined
Mar 28, 2011
Messages
7,916
Location
Southeast
To avoid these ads, REGISTER NOW!
Top Bottom