R_einan
Well-known member
Recently purchased a new air compressor for the shop, a stationary 60 gal unit from Industrial Air (http://www.industrialairusa.com/prod_detail.php?model=ILA3606056&cat=1).
I am a little less than satisfied with the design of the air intake. It is a piece of felt like material behind a mesh screen. I was considering making a steel plate to replace this system which would accept a thread in filter silencer from solberg.
Which brings me to the question: would you use 1 filter with a 3/4 outlet such as: https://www.solbergmfg.com/ViewSeriesDetail.aspx?SeriesId=2&PartNumber=FS-15-075
OR
Would you use 2 filters with a 1/2" outlet, such as https://www.solbergmfg.com/ViewSeriesDetail.aspx?SeriesId=1&PartNumber=FS-07-050
This isn't an area I have much expertise in, and while I can make the adaptor plate with no issue, my understanding of the pros and cons of either option leaves room for some enlightenment. Your thoughts?
I am a little less than satisfied with the design of the air intake. It is a piece of felt like material behind a mesh screen. I was considering making a steel plate to replace this system which would accept a thread in filter silencer from solberg.
Which brings me to the question: would you use 1 filter with a 3/4 outlet such as: https://www.solbergmfg.com/ViewSeriesDetail.aspx?SeriesId=2&PartNumber=FS-15-075
OR
Would you use 2 filters with a 1/2" outlet, such as https://www.solbergmfg.com/ViewSeriesDetail.aspx?SeriesId=1&PartNumber=FS-07-050
This isn't an area I have much expertise in, and while I can make the adaptor plate with no issue, my understanding of the pros and cons of either option leaves room for some enlightenment. Your thoughts?