Racedeck freeflow tile colors and cleanliness

[Raptor916]

Going with freeflow after some help from forum members. I have a question about the colors mainly graphite, alloy and black. Does one show dirt/dust more than the other? I follow Racedeck on Instagram and I came across a picture which had 2 feet perimeter of graphite, 1 foot perimeter of black and the center in alloy. It looked unique, but understated at the same time.

 

[CSRPenFab]

I have a mix of black border, red band and graphite infill. No issues with any color showing dirt or dust more.

 

[kngelv]

White is really the only color that ages poorly. It does not take well to grease and tire marks. You'll be fine with the ones you like. I have blue and graphite along with yellow edging and even the yellow holds up well.

James

 

[gatorfast]

Alloy can show a bit of dirt mainly on areas the tires roll over. Graphite always looks consistent though.

 

[Raptor916]

Thanks for the replies. I basically took black, alloy and graphite in different configurations and ended up with the one below. Mostly graphite where the wheels will be.

 

[racer1735]

My floor is very similar to the red/grey shown above. It doesn't show dust much at all. The only times that it gets dirty enough to warrant washing is when a car tracks in rain or (worse) snow and its accompanying grit.

 

[BroncoAZ]

I don’t have any issue with dirt showing up on my mostly alloy floor. The light blue shows a little bit of grime once in a while, but it wipes off easily. I’m glad I went with the alloy as the primary color, the graphite would’ve turned out too dark. Graphite is the dark strip between the two different blues in the stripe.