To avoid these ads, REGISTER NOW!

Replacement Bits for Picquic (or other) Multi Screwdrivers

P

peteco

Well-known member
Joined
Feb 23, 2008
Messages
210
I have several Picquic 6-in-one screwdrivers and they are great. Have a couple Milwaukee copies as well and they are good too. One problem with the Picquic bits is they seem to wear quickly and the Phillips start to "cam-out" badly. Has anyone found a replacement 3-inch long bit that would be better.

I see there is a Wiha Phillips bit that is 3-1/2 inch long that I would need to cut off to fit. The hex part runs almost the entire length which is what the picquic bits are.

 
To avoid these ads, REGISTER NOW!
M

matthew

Well-known member
Joined
Dec 4, 2009
Messages
1,347
I think the original bits are 2-3/4” long???

I agree, the Picquic handles are excellent, but the bits are a bit soft. I also prefer bits that have a round shaft, and Phillips with ACR.

I bought some Exchange-a-bit round shaft bits at the hardware store for when my bits are worn again, but they’re not ACR. I’ve been watching for other options.

2” bits would be a tad stubby, but would work fine.

Something like this - Link - would work.

I think Wiha has 70mm bits too, just not ACR.

Zephyr E1102XX275R would be great - just not as easy to find, and ACR is in the removal direction only.

I don’t know if Vega is any good, but I had ordered this to find out - Link - but Amazon cancelled my order.
 
Last edited:
To avoid these ads, REGISTER NOW!
G

Grokew

Well-known member
Joined
Jan 4, 2020
Messages
356
Location
Home
Updating

Makita XPS impact bits are available in 75mm length
Felo offers bits in 73mm length (just a tiny bit shorter than the picquic)
Vessel also has 75mm bits and they are JIS too.
 
You must log in or register to reply here.
To avoid these ads, REGISTER NOW!
Top Bottom