Rustoleum Epoxy Shield and Sealant

[will319]

Two days ago I went ahead and used the Rustoleum Epoxy Shield kit on my garage floor and used the flakes. I added the Behr fine sand to the paint to give it some traction. I wasnt quite sure if you guys would recommend putting a sealer on it. If so should I add more sand to the sealer to give it some grip when it gets wet or snows here in MD. Theres also a spot that I was running out of flakes on the floor by the door and it looks a little bare. I wasnt paying enough attention towards the end. I figured if I went and took some spray adhesive and some more flakes I could glue them then epoxy seal over them a day later. The problem is I am having a party in 5 days. If I glue chips tonight, finish painting the block edge around the garage and seal it tomorrow; would that be enough time for the epoxy sealer to harden for use.

Thanks for the input.

 

[BMcC]

I'm not sure if you should try to glue the flakes down, but one of the epoxy vendors on here might have more information how to go about it. I think they generally recommend doing a clear coat over everything if you want to keep it shiny.

Regardless, welcome to the Garage Journal, and post some pictures of your project.

 

[Fredartic]

pictures of your finish floor would be appreciated, Will. Hope it turned right finally.