Shoehorned mini split.

[Spikes]

I didn't have room to install the inside portion of a mini split in the garage, so I had to mount it at an angle. It's working perfectly and I now have heat and air.

 

[jlv03]

Interesting use of a TV mount!

 

[bluedog225]

Nicely done. I probably want to tie that swing arm mount to the wall with something that could exert some tension. That will keep it from wanting to walk out with minor vibration overtime and put strain on your copper and wires.

 

[Spikes]

Nicely done. I probably want to tie that swing arm mount to the wall with something that could exert some tension. That will keep it from wanting to walk out with minor vibration overtime and put strain on your copper and wires.

That was a concern during the planning phase, but it's rock solid with the pressure lines, drain and wiring going straight into the wall on the viewer's right side of the unit. There's no vibration or movement.

 

[dscheidt]

That was a concern during the planning phase, but it's rock solid with the pressure lines, drain and wiring going straight into the wall on the viewer's right side of the unit. There's no vibration or movement.

Is it secure against someone grabbing it and moving it? a couple pieces of chain might save a bunch of trouble.

 

[kngelv]

I like the ingenuity of this set up. Good job.

 

[fitter30]

 

[aggie113]

That wall mount is making my brain twitch... Hopefully it stays good over time. Another way to do a corner mount like that would be to do a triangle into the corner bringing out a flat surface for you to mount something to.