To avoid these ads, REGISTER NOW!

Shop upgrades

To avoid these ads, REGISTER NOW!
J

jblnut

ALLIANCE MEMBER
Joined
Jan 17, 2015
Messages
7,023
Location
In the Middle of MN
6-3/4” overall diameter with a 3/16” wall. Loft will be above my weld/fab area and 18x27’6” when finished. Pretty stoked !!
 
B

Boilerhouse

Well-known member
Joined
Mar 20, 2012
Messages
1,320
Location
Muskoka
Half the bulbs were burnt out in the shop, so decided - it's time. Replaced 10 x T8 fixture bulbs (20 bulbs) with by-pass ballast double end LEDs. Replaced 5 x T12 fixtures (10 bulbs) with new LED fixtures. No photos necessary - just imagine dark....then bright.

Now that I can see - more upgrades to come.
 
C

CraigStu

Well-known member
Joined
May 22, 2014
Messages
4,033
Location
Blacksburg, Va
LEDs are great aren't they? One huge advantage is the much reduced power consumption. Not so much cutting your bill, but in a retrofit, you can add a bunch more lights to the original wiring/breaker circuit because the consumption is so low.
 
To avoid these ads, REGISTER NOW!
T

tarmy

Well-known member
Joined
May 28, 2014
Messages
4,680
Location
Nor Cal
racecougar said:
Picked up some new cabinets and moved one of the Kennedy bottom boxes from the house garage to the shop recently. Then this guy arrived for Christmas. Everything in the shop is about to be labeled!

IMG_3341.JPG
Click to expand...
That is incredibly handy. I have had one for years and use it often. If you haven’t, look at the material and finishes on the various types of base label material they have. All kinds of options and types.
 
R

racecougar

Well-known member
Joined
Jan 26, 2021
Messages
5,079
Location
Missouri
tarmy said:
That is incredibly handy. I have had one for years and use it often. If you haven’t, look at the material and finishes on the various types of base label material they have. All kinds of options and types.
Click to expand...
Yep, I've started down that rabbit hole. I bought a few different sizes and materials. It's cool how many different options are out there. Wish they were a bit less expensive though.
 
OP
C

craftsman creep

Well-known member
Joined
Dec 28, 2022
Messages
299
So I got this shelf from a vet clinic to replace an old plastic Cabinet and it worked fine but other then the stuff In the Organizers everything was still in coffee cans.IMG_1973.jpegThen today me and my dad took two shelf’s apart at a vet clinic and I new it needed the one.
IMG_2208.jpeg
I had the tool box from my old set up and it had just been sitting not getting used so I decided to put it in there and use it to hold everything the was in the coffee cans. The drawers one the right I had and from my grandpa they have some stuff in them. And this doubles as a extra bench cause you always need more bench.
 
You must log in or register to reply here.
To avoid these ads, REGISTER NOW!
Top Bottom