To avoid these ads, REGISTER NOW!

Snap on mt631a chargematic

WickedMainer

Well-known member
Joined
Dec 13, 2016
Messages
119
Anyone else have one of these or restored one? It's a 1962 snap on chargematic mt631a I believe. Couldn't find much on it other than the catalog listing. Came from the dump Saturday. Doesn't work but looks awesome. Going to be my crash course in electronics I think.
 

Attachments

  • IMG_0712.jpg
    IMG_0712.jpg
    138.5 KB · Views: 27
  • IMG_0720.jpg
    IMG_0720.jpg
    137.1 KB · Views: 24
  • IMG_0721.jpg
    IMG_0721.jpg
    139.4 KB · Views: 22
To avoid these ads, REGISTER NOW!

6PTsocket

Well-known member
Joined
Mar 12, 2014
Messages
4,593
Just clip the cables to the electrodes on either side of the monster's neck.

Sent from my SM-G900V using Tapatalk
 
OP
W

WickedMainer

Well-known member
Joined
Dec 13, 2016
Messages
119
Haha yea I'm right there with you, but honestly I think the extension cords some people use are even scarier. Needless to say, I have no intentions of using this inside my house or shop if I'm not in the same area.
After I found some fire spliced wires in my house(almost every long run was 6-12' pieces electrical tapes together)when I renovated upon buying, I put in arc fault breakers and ripped out a lot of the wiring. Wiring I replaced is now all 20amp circuits and overkill on the gauge because it was what was left over from another project. House was built in 82 and that was the original wiring. I bought the place probably 3 years ago. I can't believe the workmanship of some of these low cost chain builders. My first floor back wall is 4" out of plumb and to correct it they made the second floor back wall come in 4". Vinyl hid it completely. The kitchen is on the back wall. What fun shimming the studs was so I could put new cabinets in. Old ones were built in place and scribed to the angle.
 
To avoid these ads, REGISTER NOW!
OP
W

WickedMainer

Well-known member
Joined
Dec 13, 2016
Messages
119
:eyecrazy: we came across some bad foundation pours but never a foot! Guy We used to use, when it was up to us, and before I bought my own forms, guarantees within 1/2" or gives you half off, over 1" free.
 

6PTsocket

Well-known member
Joined
Mar 12, 2014
Messages
4,593
I like the idea of restoring an old charger. Open it up. Let's see what is inside. Any info. available from SO. The old rectifiers will have to be replaced with silicon Selinium had a limited life span. If the power transformer is not shot, anything else is managable.

Sent from my SM-G900V using Tapatalk
 
To avoid these ads, REGISTER NOW!
Top Bottom