On the local-inspector front, I'm sure I could get busted for something. But sheds and playhouses that are less than 120 sf (and don't have electric or plumbing) are exempt from needing a building permit.
Today the kids didn't have school, because of a bomb threat. So there was more babysitting than usual. But if you can't use that time to get some garage-based chores off your list, then I figure the terrorists have won.
So I did three small projects today. First, I test-installed wood blinds in the playhouse. These were a dumpster find from the other day. Then I put in a floor on top of the plywood. It's just vinyl, but it only set me back $36 and it should hide dirt better than the plywood did. And I also made a wing.
Here's the floor. It's supposed to look like rough-cut driftwood:
I sewed those curtains, too.
Here you can see the blinds -- tilted to match the windows. If I decide to keep them there, I'll take them back down and paint them to match the trim.
Another shot that shows both the blinds and the flooring. I don't know if I'd use either in my house -- but this is a playhouse:
I still have to clean up and repaint that table set.
Then I made a new wing for the two times I'll be taking the race car out over the winter break. I'm going for a personal best at the local track, and this wing is 10 full inches wider than the one I normally bolt on. I was going to fiberglass it today as well, but decided to try just a coat of acrylic to see if that will work all right for this one, since it will only see a couple of uses.
Following my research for building a teardrop camper, I have (I hope) a better way to adhere the wing and mounts together.
A lot wider than the regular one:
Primer:
And paint:
I'm testing the idea of a big increase in aero -- since a track record for production cars was just set by a Dodge Viper ACR, which has a crazy-huge wing and splitter. I don't have the horsepower to push as much air as a Viper -- but I'm going to try a bit more wing in back, slightly different overall rake, and some other stuff up front. We'll see how it goes.